HydrO2 Silica Spray Concentrate

HydrO2 is a time-saving product. Creates an instant shine. You only need a wet surface, spray the product and rinse it with a regular or pressure hose. HydrO2 is activated by contact with water.

Characteristics:

• Value: It is a super concentrated product. Recommended dilutions are: 6:1, 10:1...you can experiment with different dilutions to find a personal option.
• CQUARTZ compatible. It can be used to maintain paints with ceramic coatings.
• Versatility: Use on any surface. Apply to areas you never could before. Paint, Glass, Plastics, Rings, Grills, etc.
• Easy to use
• Instant: No curing time.
• UV Protection: Offers significant protection against UVA and UVB rays.
• Beauty: Instantly revives the high shine, deep luster, and smoothness of your paint
• Durability: 2 to 4 months

Dilution:

• For greater durability dilute 6:1 (example: in a 32 oz bottle mix 4 oz of Hydro with 26 oz of distilled water).
• A balanced mixture is 10:1 (example: in a 32 oz bottle mix 2.9 oz of Hydro with 29.1 oz of distilled water). This means that the 3 oz Hydro bottle produces 32 oz of mix. This bottle mixed by diluting 10:1 can make approximately 5 to 8 cars (including glass, paint, and rims)
• Yes, you liked the idea of Hydro, but you don't want to dilute the product; you can try Hydro Lite you don't have to dilute it.
• I recommend only diluting in 32oz bottles at most, if it's just to maintain your cars. If you know you will use more product in about a month, you can dilute it in larger containers.

Instructions:

1. Work in the shade and with a cool surface
2. Wash the vehicle and DO NOT dry. The surface where you will apply Hydro must be wet
3. Divide the vehicle into smaller sections to work on.
4. Apply with a spray bottle to paint, glass and plastics. Remember that the surface must have water and the surface must be cold.
5. Immediately after finishing applying to a section (30 seconds maximum), rinse the surface with water. Observe that a foam forms and the water begins to slide off the surface. It is important to take into account that when spraying the product, it may fall into another section that is nearby; This means you have to rinse around where you apply. (example is applying to a front mud guard, it is very likely that with the wind, the product will fall on the bonnet. You must rinse the bonnet and the guard).
6. Repeat the process of applying and rinsing the surface until the entire vehicle is finished.
7. Then dry the car. You will notice the shine and softness on the surface. If you notice any stains or product residue you can apply the same Hydro mixture to a microfiche cloth and wipe away the residue. I have also tried using Echo with great success to remove residue.